1. Manually turn on the component
you want the remote to control
(TV, VCR, DVD, satellite receiver
or cable box).
2. Locate the enclosed Code Lists.
Find the list for the component
you wish to program. Find your
component’s brand. You will
see a listing of four-digit codes
for each brand. If your brand
isn’t listed, use the Manual Code
Search method to program the
remote control. (Refer to page 6 for
Manual Code Search method.)
3. Press and hold the component
key (TV, VCR, DVD, SAT·CBL)
you wish to program. The LED
indicator light turns on and remains
on. If you release the component
key any time during the Direct
Code Entry procedure, the LED
indicator light blinks four times,
and the process is exited.
Programming the Remote
Your universal remote can operate a variety of brands
of components. In order for your universal remote to
control your components, you need to program the
remote with the codes that match the components (See
Code Lists enclosed). These codes enable the remote
to communicate with your components. Each brand
and each component has its own “language,” and, by
programming the correct codes into your remote, you
tell the remote to “speak the same language” as your
components.
There are two methods you can use to program your
remote control to operate your components: Direct
Code Entry and Manual Code Search and Entry. Most
components can be programmed in one of these ways.
Try them in the order listed.
In order to control combo TV/VCR or TV/DVD units,
you must program both the TV key and the VCR or
DVD key. Once programmed successfully, the TV key
controls the TV functions on your unit, and the VCR or
DVD key controls the VCR or DVD functions. There is
a specific section in the Code Lists for combo units. The
codes in this section should be tried first, using Direct
Code Entry on the TV and VCR or DVD keys. If this is
unsuccessful, follow the normal programming methods
for both the TV and the VCR or DVD keys.
Programming Methods
Direct Code Entry
To program your universal remote to control your
components using the Direct Code Entry Method,
follow the steps below.
4
LED
To Next Page
Loading...
Need help?
General
