EN
4
Operating the Radio
Tuning the Stations
1. Press ON to turn on the radio.
2. Slide the FM/AM switch to the desired
broadcast band.
3. Turn the TUNING knob to select a
station.
4. Press OFF to turn off the radio.
Built-In AFC
The Built In Automatic Frequency Control
(AFC) works only on FM. It helps reducing
drift on FM reception and keeping the
radio locked in on the FM station to which
it is tuned.
When tuning in FM stations, you may
notice that the station you are tuning can
be well-tuned on two or three nearby
points on the dial. Always tune carefully
at the loudest and clearest point.
Antennas
AM Antenna - A built-in ferrite rod
antenna eliminates the need for an out-
side antenna for AM reception. Rotating
the unit slightly may improve the recep-
tion of distant AM stations.
FM antenna - The power cord acts as your
FM antenna. It picks up moderate to
strong stations and eliminates the need for
an external antenna in most strong signal
areas. Be sure the power cord is stretched
to its full length. Do not coil or bunch the
cord together. Changing position of the
power cord may improve reception.
AM
FM
TUNING
AM/FM
Tip:Tip:
Tip:Tip:
Tip:
You may try to move the
power cord in order to im-
prove the reception.
To Next Page
Loading...
Need help?
General
