11
EN
Radio
Selecting Tuner Band
1. Press SOURCE to select TUNER.
2. Press BAND to select between AM or FM radio
band.
Tip: Your audio system has 32 preset stations.
Tuning to a Station
Press SKIP BACKWARD / FORWARD
on the main unit or TUNE REW /TUNE F FWD
on the remote control to select frequencies.
Using Presets
The tuner can be in either TUNE or PRESET mode.
When in PRESET mode, the PROG light is on.
• Press TUNE/PRESET on the main unit to toggle
TUNE and PRESET mode.
• Press SKIP BACKWARD or SKIP
FORWARD on the main system or
PRESET PREV or PRESET NEXT on the
remote control to access the previous or next
preset station. The display first shows the preset
program number and after a few seconds, the
frequency will be displayed. (FMPR:01 is FM
preset 1)
Auto Preset Programming (for FM only)
Press and hold BAND/AUTO PROG. button for 2 sec-
onds to scan stations in FM band. The stations will
then be stored as preset channels. A maximum 32 sta-
tions can be stored. Beware of your preset channels
being erased accidentally because the scanning and
storing process is automatic upon pressing and hold-
ing the button. You can stop the automatic scan by
pressing any button, but the erased stations cannot be
recovered.
Manually Setting Presets
1. Press TUNE/PRESET button to enter TUNE mode.
2. Press SKIP BACKWARD / SKIP FORWARD
to access the desired frequency.
3. Press the PROG/SET button once.
4. The most recently accessed program location will
be displayed.
5. If a different program location is preferred, press
SKIP BACKWARD / SKIP FORWARD
to move to the desired preset number (1-32).
6. Press PROG/SET to store the selected frequency at
that preset.
Suppressing Stereo Signal
Press CD DISPLAY/ FM ST to toggle between FM
mono and stereo for stereo FM stations.
PR:01
87.50 MHz
AUTO PROG.
O.K.
To Next Page
Loading...
Need help?
General
