9
1. ON/OFF
To turn on or off the receiver and
other auxillary components (see
page 10 “Using the Remote to
Control Additional Components ”).
2. Sour
c
e Buttons
To turn on and select various
audio/ video sources. You can also
enter the 6 Channels direct input
mode by pressing DVD•6CH.
3. CH+, CH- (Channel Buttons)
To select programmed stations (in
TUNER mode).
4. VOL (Volume Buttons)
To adjust the volume.
5. MUTE
To mute all audio outputs.
6. Adjustment Buttons
Press AUDIO button to activate
the control, then upon press ing
OK, the display will toggle among
Preset EQ (Stereo only), SLEEP
Mode & DIM Mode. When the
display sho ws the setup you want
to change, press the left and right
arro w buttons beside OK button
to make c hanges, then press OK to
finalize your choice.
7. Number Buttons
To access directly a pre-set station
(in TUNER mode).
8. MENU
Press to store desired frequency in
memory. The flashing w ord MEM-
ORY in red will appear in display.
Input your desired channel num-
ber w hile the word is still flashing
and the frequency will be stored.
(For details, refer to " Storing and
Recalling Stations in Memory " on
page 10. )
9. Operation Buttons
In TUNER mode, you can press
REVERSE and FORWARD keys to
tune down or up the radio fre-
quency. PLAY, RECORD, STOP
and PAUSE keys are for easy con-
trol of components (like CD, TV,
DVD, TAPE, etc . ) other than the
receiver itself. W hat you need is to
encode the components in
advance. (For details, refer to
" Using the Remote to Control
AdditionalCcomponents " on page
10.)
10. DIGITAL
Select the way your audio/video
components are connected to the
receiver – A nalog, O ptical, or
Coaxial.
11. LEVEL
Press to adjust the volume of indi-
vidual speaker. Press repeatedly
and the display will toggle among
different channels (Left main
speaker, Right main speaker,
Center speaker, Left surround
speaker, Right surround speaker,
and/or Subwoofer, if available),
then press the left and right
arro w buttons beside OK button
for adjustment.
12. SURR (Surround Sound
Control)
Press to change the surround
sound settings. The display will
toggle among DOLBY DIGITAL ,
DOLBY PRO LOGIC, DOLBY 3
STEREO, STEREO and DSP modes.
(For details, refer to s ection
" A dvanced Sound Control " on
page 11. )
Note: The remote buttons GO
BACK•DISK, GUIDE•RDM•PTY,
INFO•RDS, CLEAR, INPUT•SEEK
& ANT•FMS do not w ork with the
receiver.
Operating your Re
c
eiver
Your Remote Control
Please be sure you have inserted the batteries into the remote control (see
relevant section on page 3. ) You can test it by pressing any button. If it
works, the red LED will light.
To Next Page
Loading...
