14
EN
Care and Maintenan
c
e
Troubleshooting Tips
Re
c
eiver/Tuner Operation
STEREO indi
c
ator is off.
• A djust the antenna.
The signal is Mono. Severe hum or noise.
• The signal is too weak. Connect an external anten-
na.
Remote Control Operation
The remote
c
ontrol does not operate the unit.
• A nother function mode is selected on the remote.
Press the correct Source Button.
• No batteries installed. (included with your system)
Install the batteries before attempting to operate the
remote. Be sure to match the + and - ends of each
battery to the symbols sho w n in the remote battery
compartment.
• The batteries are w eak. Replace all batteries.
• The remote is not pointed at the remote c ontrol
sensor on the main unit or there is an obstacle
between the remote and the main unit.
• The remote control is too far from the main unit,
move closer.
General
No audio.
• Make sure the speakers are connected.
• Check the connections.
• Check the po wer cord connections.
• Make sure the MUTE indicator on the front panel
is off.
• Make sure the digital setting (optical, coaxial or
analog) is correct.
• Check if connections is different from recommen-
dation when SDET is O N (see p.12 Smart Detect).
No audio from one
c
hannel.
• Chec k the speaker level setting.
• Chec k the speaker wire or cable connections.
Noise
c
reates when the TV is turned on.
• The TV is too close to the audio system.
Spe
c
ifi
c
instruments sound displa
c
ed.
• Check the connections bet w een the receiver and
the speakers if the sound does not match the video.
• Press the S ource Button for the video source.
Cleaning the Exterior
• Disconnect the system from AC po w er before
cleaning the exterior of the system with a soft dust
cloth, or with a slightly humid chamois leather. Never
use strong solvents.
Equipment Spe
c
ifi
c
ations:
AMPLIFIER SECTION:
All 5 channels: each 100W at 6 ohm.
0. 9% THD @1 kHz
Subwoofer channel: 200w at 3 ohm (RT2500 only)
Muting Attenuation: 65dB
Frequency Response: 40Hz to 20kHz +/-3dB
Signal to Noise Ratio: 65dB (Bypass mode)
VIDEO SECTION:
Input ( Sensitivity/ Impedance ):1Vp-p/ 75ohm
Output (Level/ Impedance): 1Vp-p/ 75 ohm
Frequency Response: 10Hz to 6MHz at +/- 3dB
Signal to noise ratio: 40dB
Crosstalk @3. 58MHz: 40dB
AM TUNER SECTION:
Frequency Response: 80Hz – 2kHz +/-6dB
Usable S ensitivity: 800uV/m @ S/N 20dB
Signal to Noise: 38dB
Image Ratio: 27dB @ 1000kHz
IF Rejection: 35dB
FM TUNER SECTION:
Frequency Response: 40Hz – 15kHz +/-3dB
Quieting: 24dBu
Signal to Noise: 60dB(stereo)/ 65dB(mono)
Image Ratio: 40dB
IF Rejection: 50dB
To Next Page
Loading...
Need help?
General
