EN
17
16
Advanced Sound Control
Stereo
The Stereo mode uses the two main channel outputs from
the front speakers and subwoofer channel.
Fine Setting of the Components
The receiver can be directly turned on by pressing the
SOURCE buttons on the remote (like DVD/CD, SAT), which
also selects the best surround sound mode. The default sur-
round modes for different components are as below.
If you decide to change the surround mode, you can press
SURROUND repeatedly to toggle among the different sur-
round mode choices and select the one you want.
For Digital Signal (Dolby Digital)
Dolby Digital 3 Stereo Stereo
For DTS Signal
DTS Stereo
For STEREO Signal
Stereo Dolby PL II Movie Dolby PL II Music Dolby
PL Emulation 3 Stereo Arena JazzClub
Theater Stadium Disco
Default Settings
The receiver will keep the last selection in memory as long
as it doesn’t enter standby mode.
DEFAULT INPUT (as seen on display)
Analog (SAT)
Analog (VCR)
Analog (TV)
Built-in Tuner
Built-in
SOURCE
SAT
VCR
TV
TUNER
DVD/CD
Advanced Sound Control
Fine Setting of the Speakers
All the basic settings have already been presetted for the
speakers included in the box.
However, to make the surround sound more effective and
suit the acoustic conditions in your listening room, you may
need to delay the signal coming from some of the speak-
ers. Channel delay compensates for center or surround
speakers that are closer to the listening position than the
front speakers.
You may setup the speakers channel by channel: first, press
the MENU button while in stop mode to enter the setup
menu, then choose SOUND for speaker setup.
To change the speaker setting
In the SPEAKERS menu, press UP/DOWN to select a speaker.
When the speaker picture is selected, you may press
UP/DOWN to change the speaker setting (YES / NONE).
To change the speaker distance
In the DISTANCE menu, press UP/DOWN to select a speaker.
When the speaker distance column is selected, you may
press UP/DOWN to adjust the distance from the front, rear
and center speakers individually.
To test the speaker setting and change the speaker
level
In the TEST menu, a short noise will come from each speak-
er respectively, press UP/DOWN to configure the currently
playing speaker, then press OK to activate.
Advanced Setting
Factory Default Setting
The receiver speaker distance default settings are the
following:
Front speakers (L/R) 15 ft
Center speaker (Cch) 15 ft
Rear speaker (SUR) 10 ft
IMPORTANT NOTE
• Always use the subwoofer for optimum sound
quality.
To Next Page
Loading...
