DVD Player
EN
21
DVD Player
20
Selecting a title
1. Refer to the previous page “General use” to open the
title menu. Then press OK.
2. Enter a title number using the number keys on the
remote control. You can also use UP/DOWN to change the
title number.
Selecting a chapter
1. Refer to the previous page “General use” to open the
chapter menu.
2. Enter a chapter number using the number keys on the
remote control. You can also use UP/DOWN to change the
chapter number.
Selecting an audio language
1. Refer to the previous page “General use” to open the
audio menu, or press AUDIO on the remote control to
select the audio channel.
2. Press UP/DOWN to select the audio channel you want,
then press OK to confirm.
Selecting a subtitle language
1. Refer to the previous page “General use” to open the
subtitle menu.
2. Press UP/DOWN to select the subtitle you want, then
press OK to confirm.
Note:
To exit the OSD banner, press the INFO key.
Slow motion playback
1. Press PLAY/PAUSE on the main unit or PAUSE on the
remote control to freeze the picture during playback.
2. To advance picture in slow motion. Press FORWARD on
the remote control for forward slow motion and REVERSE
(DVD only) for backward slow motion
Press repeatedly to change speed to 1/16 times, 1/8 times,
1/4 times and 1/2 times.
3. Press PLAY/PAUSE on the main unit or PLAY on the
remote control to resume normal playback.
Progressive scan
1. Make sure the component output is connected to a TV
which accepts progressive scan signal. To enable progres-
sive scan, press and hold SUBWOOFER for 3 seconds in
STOP mode.
2. Press SUBWOOFER again to toggle progressive scan
function between ON and OFF. The green light will be on if
the progressive scan function is active.
On-screen banner display
You can access the on-screen banner display during play-
back to select many playback features. Each feature is illus-
trated with an icon. However, each feature shown in the
banner is available only if the disc was created with that
particular feature.
An invalid icon appears on the screen when you
select an icon that does not function. Also, the icon
is “greyed out” to tell you so.
General use
1. Press INFO on the remote control during playback to
show the on-screen info banner.
2. Use the LEFT or RIGHT arrows on the remote control to
move the cursor on the banner, the selected feature icon
will be highlighted.
3. Press OK to open the menu corresponding to the select-
ed feature.
To Next Page
Loading...
