RCA VR354 - Auto Play; Energysaver

18
Setting Up the VCR
Use the compatible remote to change the remote setting back
to VCR1. Display the PREFERENCES menu, press 1, and then press
VCR on the VCR’s remote.
Auto Play
This feature allows the VCR to automatically start playing when
you insert a tape with the safety tab removed. Press 2 to switch
between ON or OFF.
• Select ON if you want a tape with its safety tab removed to
start playing automatically when the tape is inserted.
• Select OFF if you do not want a tape with its safety tab
removed to start playing automatically.
Auto TV/VCR
To view a signal from a VCR connected to a TV with a standard
RF coaxial cable, the TV/VCR button on the remote control must
be pressed in order to see the signal.
When Auto TV/VCR is turned on, the signal will be changed to
VCR automatically, eliminating the need to press the remote
control button.
• The TV must be tuned to the VCR viewing channel (usually 3
or 4) to see the signal.
• Select OFF if you do not want the VCR’s signal to change
automatically to VCR when a tape is inserted and played.
EnergySaver
By default, this VCR automatically turns off after two hours of
inactivity. Press 3 to change the time delay, or to disable the
feature.
• OFF: The VCR will remain turned on until you shut it off.
• 1:00, 2:00, or 3:00: The VCR turns off after one, two, or three
hours of inactivity.
Thirty seconds before shutting off, the VCR will warn you with a
screen reading, “The VCR will turn off in 30 seconds. Press any
key to cancel.”
If you use the VCR’s tuner instead of your TV to tune channels,
you may want to turn this feature off.
Auto Play
For a tape to be able to start playing
automatically, it must have the safety
tab removed. All rented movies and
purchased movies should have this
tab removed.
PREFERENCES
1 Remote Control: VCR1
2 Auto Play: OFF
3 Auto TV/VCR: OFF
4 EnergySaver: 2:00
5 Front Panel: AUTO
6 Tape Speed: SLP
7 Set Auto Repeat
0 Exit
The PREFERENCES menu allows you
to access settings for your remote control,
EnergySaver and front panel brightness options.