Switch the ON/OFF switch on the headphone receiver to OFF.
Plug the charge output plug, located on the back of the
transmitter, into the charge input jack of the headphone
receiver to charge the batteries.
The charging process starts automatically and the RED LED
lights up indicating the unit is charging.
After the quick charge is completed, the quick charge indicator
will be OFF; however, the trickle charge will continue.
Caution:
Do not use other kinds of batteries to replace the Ni-Cd quick
charge (AA) battery When you are not using the head-
phone, please switch it off as the batteries can be damaged.
Headphone
Red LED
The Ni-Cd (nickel cadmium) batteries must be fully charged prior
to operation. An initial charge of 24 hours is required to ensure
the extended life of the Ni-Cd batteries. Be sure the headset is in
the OFF position during charging status.
6
To Next Page
Loading...
Need help?
General
