Need help?Do you have a question about the RCBS CHARGEMASTER LITE and is the answer not in the manual?
General| Capacity | 1500 grains |
|---|---|
| Display | LCD |
| Accuracy | +/- 0.1 grain |
| Power Source | AC Adapter |
| Features | Auto-calibration, trickle mode |
| Calibration | Auto and manual calibration |
| Type | Electronic powder scale and dispenser |
Read instructions carefully to avoid serious injury, death, or property damage. Contact support for questions.
Read all instructions, understand operation, contact support if needed. Keep manual with equipment.
Wear safety glasses, be attentive, don't rush, maintain good housekeeping, keep away from children.
Store powder away from children, heat, and moisture. Use only identified powder sources.
Calibrate before each use after 15-20 minute warm-up. Perform without the powder pan.
Follow steps involving [CAL] key and weights to set up the scale accurately.
Temperature, surface, static, and jarring can impact accuracy. Use and care for calibration weights.
Static can cause erratic readings. Use anti-static measures on the scale and cloth.
Stop use if powder enters unit. Do not press on the platen as it can damage the load cell.
Keep detailed reload records. Save original packaging for unit transport and storage.
Store and use at room temperature. Avoid cold or freezing temperatures to protect the load cell.
Identify scale, adapter, weights, pan, manual. Power: 100-240VAC, 12VDC 1A.
Capacity up to 2000.0 grains ± 0.3 grain. Treat as a fine instrument, avoid dropping.
Learn the meaning of Stable, Over, Under, Auto, and Manual indicators for proper operation.
Details the function of Power, GO, CAL, ZERO, MODE, UNITS, TRICKLE, and CANCEL keys.
Warm up scale, remove powder pan, and ensure stable readings before starting calibration.
Follow sequence: [CAL], C0, [CAL], C50+weight, [CAL], C100+weight, [CAL].
Remove weights, scale shows 0.0 GN. Place pan and press [ZERO] to complete.
Errors usually mean incorrect weights. Use provided calibration weights for accuracy.
Enter weight, press [GO] to dispense. Use [ZERO] to clear, [CANCEL] to exit. Fine-tune with [TRICKLE].
Press and hold [TRICKLE] to dispense powder slowly. Release to stop dispensing.
Hold [MODE] for 'Auto'. Enter charge, press [GO]. Scale auto-dispenses when pan is placed.
Place tray, turn spout, push dispense button. Use brush to clean reservoir. Close spout when done.
One-year warranty against defects. Requires return with receipt and fee. Excludes misuse, modification.
Implied warranties are limited. RCBS not liable for consequential damages. State laws may apply.
Phone: 1-800-379-1732. Email: rcbs.tech@vistaoutdoor.com. Visit www.rcbs.com.
RCBS is Precisioneered Reloading Equipment. RCBS is a registered trademark of Vista Outdoor Inc.
To Next Page
