25
ENGLISH
POWER SUPPLY VOLTAGE CHANGE
IMPORTANT: This manual section is for qualified personnel only.
The following instructions are to be ignored by users.
Make sure the device is not connected to the mains (unplug the power supply cable).
Remove the lid.
Find the 230 / 115 V voltage change connector (in the picture, it is highlighted by a square):
According to the PCB indication, if the mains voltage is 230 V, set the connector to the 230 V
position, if the mains voltage is 115 V, set the connector to the 115 V position.
Refit the device lid.
Before connecting the device to the mains, make sure that the fuse (inside the IEC power supply
connector of the rear panel, see 24) is the correct current rating for the mains voltages (read the fuse
indication below the connector).
To Next Page
Loading...
