Troubleshooting
CIRCUMSTANCE ITEMS TO BE CONFIRMED SOLUTIONS
Alarm sounds with
HI indication
(abnormal high temp.)
Alarm sounds with
LO indication
(abnormal low temp.)
ઔ Connect the cord again.
ઔ Check the main socket with any other
electric appliances.
ઔ Try to insert to another outlet.
ઔ Check electric cord is properly connected.
ઔ Check if there is a power outage.
ઔ Check whether the plug is damaged.
Temperature will
not go high enough.
No signs of power
to the incubator.
ઔ Check your setting temperature.
ઔ Check the air circulation FAN is working.
ઔ Initialize the incubator.
[Refer to the page 11]
ઔ
Set the temperature as required.
ઔ
Take the power plug out of the outlet, and
disassemble the main body for cleaning
around the air circulation fan with brush.
ઔ Supply water.
ઔ Set the humidity again as required.
ઔ Check your setting humidity.
ઔ Close the view window again after checking.
ઔ Initialize the incubator. [Refer to the page 11]
Humidity will not
go high enough.
Egg-Turning fails
to work.
ઔ Check that the Egg-turning stoppage is not
activated. (Egg-turning lamp lighting)
ઔ Check that there are no foreign items on the
egg turning tray.
ઔ Check if egg turning plate is assembled correctly.
[Refer to the page 9]
ઔ If you need to turn the eggs, you can
manually re-start egg-turning.
ઔ Unplug the power supply and
disassemble the main body for cleaning
the egg turning tray and gear.
ઔ Assemble egg turning plate as the picture on page 9.
Dew foams in
the incubator.
ઔ Check the incubator is not placed
too cold circumstances.
ઔ When you turn OFF incubator and then
turn on.
ઔ
Move the incubator to where the ambient air
temperature is over
28℃ (82.4℉)
ઔ Dew condensation is normal.
ઔ Dry the incubator completely under well ventilated place.
ઔ
Take out the plug out of the outlet and
disassemble the main body and clean
around the air circulation fan with brush.
ઔ Check if there is any hatching debris such as
feather or eggs-shell in the incubator FAN.
The machine makes
some noise.
- It is normal that the machine
emits some sounds because
it uses air circulation fan
for working.
ઔ Check that you have not overfilled the incubator.
ઔ Check that the incubator placed on inclined
surface.
ઔ Check if it is Dew condensation
Water leaks from
the machine.
ઔ Do not fill water over LIMIT indication.
ઔ Place incubator under a level surface.
䯝 Check if room temperature is too high
䯝 Check if incubator is exposed to the direct
rays of sun
䯝 Check if room temperature is too low
䯝 Check if incubator heater(temperature controlling-
system) is normally working
䯝 Adjust room temperature 28℃ (82.4℉)
䯝 Install incubator without the direct rays of sun
䯝 Return incubator to factory setting [Refer to page 11]
䯝 Adjust room temperature 28℃ (82.4℉)
䯝 Place thermometer inside of incubator and check
if setting temperature is correct
䯝 Return incubator to factory setting [Refer to page 11]
If you need detail self diagnosis,
please click “self diagnosis” on our website.
Be sure that the incubator works without any problem before placing eggs in the incubator.
%*(*5"-*/$6#"503
4;
6. Product Information
(2
) Troubleshooting
To Next Page
Loading...
