DCN: 140-02121-02 Page 15
SETUP Menu
User preference settings.
DEG F/C Select the temperature display mode, Fahrenheit (F) or Celsius (C).
BAKLITE Sets the time from last button press that the backlight will timeout and turn off.
The backlight will turn OFF after the selected time expires. Range:10-30 seconds. Note:
long backlight timeouts will reduce battery life.
SENSCAL Change the temperature calibration by +/- 7 degrees using the Up/Dn buttons.
INFO Menu
The INFO menu is used to display information about the thermostat. Use the Up/Dn
buttons to scroll through the various items. Thermostat information displayed:
VERSION Thermostat firmware version
ZWAVE Z-Wave firmware version
NODE ID Z-Wave Node ID
HOME ID Z-Wave Home ID
SYSTYPE
STANDARD (standard HVAC system)
HP (Heat Pump HVAC system)
If HVAC type = Standard:
FAN TYPE
GAS
ELEC
If HVAC type = Heat Pump:
CO Changeover valve type
CO COOL (changeover with cool)
CO HEAT (changeover with heat)
CLOCK Menu
Set the time and day of the week.
Time
Day
ZWAVE Menu
This menu item allows you to install or uninstall the thermostat in the Z-Wave network.
Follow the instructions in the Z-Wave Installation section.
INSTALL Install thermostat in a Z-Wave Network (when a controller is in install mode)
REMOVE Remove thermostat from a Z-Wave Network
SYSTEM Menu
SYSTYPE Select the system type, HP for Heat Pump, S for Standard (Gas/Elec)
FANTYPE Select fan type (Standard systems only), Gas or Electric
To Next Page
Loading...
Need help?
General
