To Next PageTo Next Page
Need help?Do you have a question about the RDP DR7AC and is the answer not in the manual?
Guidelines for cable shielding, grounding, and segregation for optimal EMC performance.
Instructions for mounting the DR7AC unit on a 35 mm DIN rail, including spacing.
Details on transducer, supply, and output connections using screw-clamp terminals.
How to access and identify internal controls like gain, zero, and jumpers.
Specifies voltage and current output connections between pins.
How to select gain ranges using the SW1 toggle switch for transducer output.
Description of the 25-turn potentiometer for fine gain adjustment.
Explanation of the 5-way toggle switch (SW2) for output zero shifts.
Details on SW2 toggle 6 for zeroing signal input voltage.
Description of the 25-turn potentiometer for fine zero adjustment.
Explanation of the red lamp indicating input exceeding the linear range.
Information on changing the unit's excitation voltage from 1V to 3V.
How to change the excitation frequency using jumper J1.
Configuration of the unit as master or slave oscillator using jumper J2.
Step-by-step procedure for setting up LVDT and half bridge transducers.
Procedure for setting up bipolar output configurations like ±5V or 4-20mA.
Procedure for setting up unipolar output configurations like 0 to 10V.
General