APOLLO FYM - SPREADER CONTROLLER
10
2.3 Print Calibration Data
It is always a good idea to keep a record of calibration data either in the back of the manual, or as a printout.
Connect the printer to the upper serial port. Ensure first that the port has been configured for a printer (section
4.5.1).
Selecting the "PRINT CAL DATA" menu function immediately sends the data to the serial port. The message
"Printing Data" is displayed while data transfer is occurring.
If the bar on the screen stops filling up part way, the instrument cannot communicate with the printer. Check
the connections.
2.4 Change PIN for Technician Menu
You can re-programme your own PIN for this menu. Just follow the screen instructions.
If you forget your personalised PIN, you will need to contact RDS for instructions.
To Next Page
Loading...