RDS CMM 100 - Default Chapter; Table of Contents

CMM 100 : INSTALLATION, CALIBRATION AND OPERATION
2
Contents
1. Overview _________________________________________ 4
1.1 Operation....................................................................................................... 4
1.2 Calibration ..................................................................................................... 5
2. Operating Mode __________________________________ 6
2.1 Startup ........................................................................................................... 6
2.2 Selecting the crop type ................................................................................. 6
2.3 Correcting the Moisture Reading ................................................................... 7
2.3.1 Setting the Moisture Correction Factor ............................................ 7
2.4 Displaying the Grain Temperature ................................................................. 7
2.4.1 Nudging the Temperature Display ................................................... 7
2.5 Excess Moisture Content Alarm (Harvesting) ................................................ 8
2.6 Low Moisture Content Alarm (Drying) ........................................................... 8
2.6.1 Select High / Low Moisture Content Alarm option ........................... 8
2.6.2 Set High/ Low Moisture Content Alarm Threshold ........................... 9
3. Calibration Mode _______________________________ 10
3.1 Navigating the Calibration Mode ................................................................. 10
3.2 Programming a Calibration Setting ............................................................. 11
3.2.1 Entering a Negative Value .............................................................. 11
3.3 Factor A ("A.FAc") / Factor B ("B.FAc") ........................................................ 12
3.4 Factor C ("C.FAc") ....................................................................................... 12
3.5 Moisture Content Alarm ("ALAr").................................................................. 12
3.6 Low Grain Voltage Threshold ("UOLt") ........................................................ 12
3.7 Display Smoothing Factor ........................................................................... 13
4. Diagnostic Mode _______________________________ 14
5. Data Logging ___________________________________ 15