RDS SAM 400 User Manual

1
“SAM 400”
Speed-Area-Distance Meter
Calibration and Operation
Software Reference WZ200-0 rev. 6
Electro-Magnetic Compatibility (EMC)
This product complies with
Council Directive 2004/108/EC
when installed and used in accordance with the relevant
instructions.
Service and Technical Support
PLEASE CONTACT YOUR NEAREST DISTRIBUTOR
If unknown then fax: 44 (0) 1453 733322
© Copyright RDS Technology Ltd 2007
Document number
S/DC/500-10-533: Issue 4 : 6/7/07
\UK533-4.DOC
User Guide

RDS SAM 400 Specifications

General

Brand	RDS
Model	SAM 400
Category	Measuring Instruments
Language	English

Summary

Operation

Forward Speed Display - Channel 1

Forward Speed Alarm Outputs

Information on programmable forward speed alarms and their outputs.

Area / Distance Measurement - Channel 2 and 3

Area Override and Part Width Operation

Optional Width Correction Interface

Area Compensation Interface

Calibration

Set Implement Width/Nozzle spacing

Programming the full, effective working width or nozzle spacing.

ACI Input - Set No. of Nozzles per Section

Inputting the number of nozzles per section when using an ACI module.

Metric/Imperial Selection

Speed Sensor Setup

Procedure to set the Speed Sensor Factor (SSF) using AutoCal or manual calculation.

Set Forward Speed Alarm Thresholds

Setting the maximum and high speed alarm thresholds and associated outputs.

Select Engine | Ignition Hours

Changing the RPM Sensor Factor

Procedure to set or adjust the RPM Sensor Factor for accurate RPM readings.