40
© 2006 Directed Electronics
Feature Menu 1 Descriptions
1. Engine Monitoring: Defines how the engine is monitored while
the Remote Start is active.
1. No Tach: The battery voltage will be used to monitor the
engine while Remote Start is active.
2. Tachometer: The tachometer will be used to monitor
engine speed while Remote Start is active.
2. Run Time
1. 15 minutes: The Remote Starter will shut down after it
has been active for 15 minutes.
2. 30 minutes: The Remote Starter will shut down after it
has been active for 30 minutes.
3. Crank Time: Crank Time will be in effect only when Engine
Monitoring is "No Tach" and affects the duration of the "Yellow"
Starter Output wire.
1. Normal Crank: The Starter output will be 700mS.
2. Extra Crank: The Starter output will be 1 second.
3. Super Crank: The Starter output will be 1.4 seconds.
4. Mega Crank: The Starter output will be 2.1 seconds.
4. Ignition 2 Output: This controls the output type of the high
current "Green" ignition 2 output wire.
1. Ignition 2: Output will match the Blue Ignition 1
input/output wire operation during remote start.
2. Accessory 2: Output will match the White Accessory 1
output wires operation.
To Next Page
Loading...