41
© 2006 Directed Electronics
5. Wait-To-Start: This chooses the method of Starter output delay
for Diesel engines.
1. Diesel Input wire: An input on the "Red/Blk" wire will
delay the Start output until the input ceases.
2. Diesel Timer: The Starter output will be delayed until the
timer expires. The "Red/Blk" wire will be ignored.
6. Activation Input: Selects the number of inputs from the trans-
mitter or the "Red/Wht" activation input wire to activate the
Remote Starter.
1. 2 Pulses: Two input pulse will Start and Stop the Remote
Starter
2. 1 Pulse: One input pulse will Start and Stop the Remote
Starter
7. Vacation Temp: Selects the temperature threshold that will
activate the Remote Starter when Vacation Mode has been acti-
vated.
1. 0 Degrees F
2. -10 Degrees F
3. -20 Degrees F
8. Alarm Disarm: Selects the output duration of the "Brown/Wht"
Factory Alarm Disarm wire.
1. 1 second: The output will be 1 second in duration
2. 450mS: The output will be 450mS in duration
9. Horn Output: Selects the type of output on the "Blue" Horn
output wire when the alarm is fully triggered but does not affect
the arm/disarm/remote start/programming chirp outputs
To Next Page
Loading...