Reaim BIMK - Troubleshooting Common Issues; Machine Start-up and Operation Problems; Pressure Issues and Fuse Problems

14
Troubleshooting
Problems
Possible Cause
Possible Solution
Machine
refuses to start
The machine is not plugged-in
Plug the machine in
Faulty receptacle
Try another receptacle
The fuse has blown
Replace the fuse Unplug other appliances
Faulty extension cable
Try without the extension cable
Fluctuating
pressure
The pump is drawing in air
Check that hoses and connections are
airtight.
Valves dirty, worn or sticking
Contact your service center
The water supply is not
sufficient
Increase water pressure, check for
blockages and / or change the large pipe.
Pump seals worn
Contact your nearest service center
Machine stops
The fuse has blown
Replace the fuse
Incorrect mains voltage
Unplug other appliances
Check that the mains voltage corresponds
to the specifications on the nameplate
Thermal sensor activated
Leave the machine to cool for 5 mins
Partially blocked jet
Clean the jet with a needle and by spraying
water rearwardly through the jet
Fuse blows
Fuse too small
Replace it with a fuse with higher amp
consumption than the washer.
Increase in the amperage
Try without the extension cable
Machine
pulsating
Air in inlet hose / pump
Allow machine to run with open trigger until
regular working pressure resumes.
Inadequate supply of water
generated
Increase water pressure, check for
blockages and / or change the large pipe.
Partially blocked jet
Clean the jet with a needle and by spraying
water rearwardly through the jet.
Water filter blocked
Clean the filter
Folded pipe
Unfold the pipe
Machine turns
on and off by
itself
Pump fuse and/or trigger out
of order
Contact your nearest service center
No water supply
Connect the inflow water.
Machine is on
but no water
comes out
Water filter blocked
Clean the filter
Blocked jet
Clean the jet with a needle and by spraying
water rearwardly through the jet