To change the resume condition, follow the steps in "Understanding the
Configuration Menu" to display Sc. Then, rotate TUNE to select the resume
condition.
NOTE: The resume option does not affect the priority scan. Priority
scan always resumes scanning after the carrier drops.
SETTING THE DELAY DURATION
When you set the scan resume condition to cr (carrier), the transceiver
resumes scanning after the carrier drops. The scan delay option lets you
set the transceiver to pause before resuming, so you can hear any reply.
The factory default for this option is 2 seconds.
To change the scan delay duration, follow the steps in "Understanding the
Configuration Menu" to display Sd. Then, rotate TUNE to select the scan
delay duration. You can set the delay to 0.5, 1, 2, or 4 seconds.
NOTE: The scan delay option also affects priority scan.
SETTING THE SCAN LIMITS
When you press F+\/SC or F+/\SC the transceiver scans only those
frequencies within a range you set with scan limit options. To set the
scan limits, follow the steps in "Understanding the Configuration Menu" to
display S1. Use either TUNE or the key pad to enter one of the frequency
limits. Then, press \/SC to display S2 and enter the other frequency
limit. You can enter the higher frequency as either limit.
SETTING THE VACANT SCAN DELAY
The transceiver's factory default for vacant scan is to scan down until it
finds an unused frequency. To change the vacant scan direction, follow the
steps in "Understanding the Configuration Menu" to display ud. Then,
rotate TUNE to select either UP or DN.
USING THE POWER SAVE FEATURE
To Next Page
Loading...
