To continuously scan the three priority frequency memories, press PR.
Then, press and hold down /\SC or \/SC at least 1 second,
NOTE: You must store more than one priority frequency in memory to
continuously scan priority-frequency memories.
USING THE STANDARD MEMORIES
Your transceiver has 12 standard memories into which you can store
frequently-accessed frequencies for quick access. Follow these steps to
store a frequencies in standard memories.
1. Press VF and tune to a frequency you want to store.
2. Press F and rotate TUNE until the memory number to the left of the
frequency display shows the standard memory you want to store into.
3. Press F+M-WR for at least 1 second to store the tuned frequency into
the selected standard memory.
4. To change the frequency separation or subaudible tones, press MR and
rotate TUNE to select the standard memory you want to change. Then,
refer to steps 6 through 12 under "Using the Calling-Frequency Memory."
Each standard memory can have different settings.
To set the transceiver to a standard memory, press MR. Then, rotate TUNE
or
press /\SC or \/SC to select one of the 12 memories.
To continuously scan standard memories, press MR. Then, press and hold
down /\SC or \/SC for at least 1 second.
NOTE: The transceiver stops scanning according to the scan options you
have
set. See "Setting the Scan Options" for more information.
CLEARING MEMORIES
To Next Page
Loading...
