frequency memory display.
To use the calling frequency memory, press CA at any time. The transceiver
immediately goes to the calling frequency and sets the transmit frequency,
subaudible tones, and tone squelch to the settings you programmed. To
return to the previous settings, press CA again.
USING THE PRIORITY-FREQUENCY MEMORIES
The transceiver has three priority-frequency memories. The transceiver can
periodically scan these frequencies during manual, calling-frequency
memory, or standard memory operation. Follow these steps to store a
frequency in the priority-frequency memories.
1. Press press VF and tune to the frequency you want to save.
2. Press F and rotate TUNE until either P1, P2, or P3 appears to the left
of the tuned frequency.
3. If the frequency is a repeater that requires subaudible tone access or
if you want to use subaudible tone squelch with this frequency, press
F+T-SQL so that T-SQL appears on the display.]
4. Press F+M-WR for at least 1 second to store the tuned frequency in the
selected priority-frequency memory.
5. To change the frequency separation or subaudible tones, press PR and
rotate TUNE to select the priority-frequency memory you want to change.
Then, refer to steps 6 through 12 under "Using the Calling-Frequency
Memory." Each priority frequency can have different settings.
To set the transceiver to a priority frequency, press PR. Then rotate
TUNE, press /\SC, \/SC, 1, 2, 3, to select one of the three memories.
To have the scanner check the priority-frequency memories for activity,
press VF. Then, press F+P-SC for at least 1 second. The transceiver
checks the priority-frequency memories every 4 seconds. To change the
priority scan time, see "Setting the Priority Scan Time."
To Next Page
Loading...
