press F+T-SQL so that T-SQL appears on the display.
NOTE: If you turn on T-SQL you must correctly set both the transmit
subaudible tone as described in steps 8 through 11.
5. Press and hold down F+M-WR for at least 1 second.
The transceiver stores the tuned frequency in the calling-frequency
memory, plus the frequency separation (for duplex operation) and
subaudible transmit and receive tones. For more information about
subaudible tones, see "Using Subaudible Tone Squelch" (CTCSS)."
6. If you want to set a different transmit frequency or change the
subaudible tones, press F+M-SET. The transceiver displays TF followed
by the transmit frequency.
7. Rotate TUNE to change the transmit frequency.
8. To set a transmit subaudible tone frequency, press \/SC. The
transceiver displays TC followed by the transmit subaudible tone
frequency.
9. Rotate TUNE to change the transmit frequency.
NOTE: If you do not want to transmit subaudible tone, rotate TUNE to
set the transmit subaudible tone to OFF.
10. To set a receive subaudible tone frequency, press \/SC. The
transceiver displays RC followed by the receive subaudible tone
frequency.
11. Rotate TUNE to set the receive subaudible tone frequency.
NOTE: If you do not want to use incoming tone squelch, rotate TUNE
to set the receive subaudible tone to OFF. Otherwise, you do
not hear transmissions unless the subaudible tone is present.
12. Press the PTT to save the settings and return to the calling-
To Next Page
Loading...
