Follow these steps to power the transceiver from the 1-amp, 12 volt DC
adapter.
1. Connect the barrel plug with the tip set to positive.
2. Insert the adapter's barrel plug into the transceiver's EXT DC jack.
CAUTION: Never insert the adapter's barrel plug into the rechargeable
power pack's CHARGE jack. Doing so can damage the power pack
and
transceiver.
3. Plug the adapter into an AC outlet.
Follow these steps to power the transceiver from the regulated 2.5 amp
power supply.
NOTE: You need the following materials to use the regulated 2.5 amp power
supply:
Power supply (Cat. NO. 22-120)
Two-conductor 18-gauge wire (Cat. No. 278-5670
DC power connector (Cat. No. 274-1567)
Soldering iron and solder
Volt meter or multimeter
1. Cut the two-conductor wire to the length power cord you need.
2. Strip about 1/2 inch of insulation from each end of both conductors.
3. Solder one end of the wire to the DC power connector, with the red lead
connected to the center terminal, and the black lead connected to the
outer casing.
To Next Page
Loading...
