RTL8922AE User’s Manual
The OEM integrator has to be aware not to provide information to the end user
regarding how to install or remove this RF module in the user’s manual of the
end product which integrates this module.
The end product user manual shall include all required regulatory
information/warning as shown in this manual.
2.9 Information on test modes and additional testing requirements
This transmitter is tested in a standalone mobile RF exposure condition and
any co-located or simultaneous transmission with other transmitter(s) or
portable use will require a separate class II permissive change re-evaluation
or new certification.
2.10 Additional testing, Part 15 Subpart B disclaimer
This transmitter module is tested as a subsystem and its certification does
not cover the FCC Part 15 Subpart B (unintentional radiator) rule
requirement applicable to the final host. The final host will still need to be
reassessed for compliance to this portion of rule requirements if applicable.
OEM/Host manufacturers are ultimately responsible for the compliance of the Host
and Module. The final product must be reassessed against all the essential
requirements of the FCC rule such as FCC Part 15 Subpart B before it can be placed
on the US market. This includes reassessing the transmitter module for compliance
with the Radio and EMF essential requirements of the FCC rules. This module must
not be incorporated into any other device or system without retesting for compliance
as multi-radio and combined equipment.
As long as all conditions above are met, further transmitter test will not be
required. However, the OEM integrator is still responsible for testing their
end-product for any additional compliance requirements required with this
module installed.
2.11 Note EMI Considerations
Please follow the guidance provided for host manufacturers in KDB publications
996369 D02 and D04.
To Next Page
Loading...
