RECO RM-310 C - Text Messages on the Display; Program Start; Operating Message 1

Documentation RM-310 C / RM-310 CT / RM-310 C Plug and Play / RM-310 CT Plug and Play
RDN 10001104 33 14.07.2020
8 Text messages on the display
In the operating mode of the filter control RM-310 C / RM-310 CT the following operating messages are
either displayed directly or they can be retrieved in sequence by pressing the  key or the  key. Non-
active functions are not displayed.
If no key is pressed during a duration of 3 minutes the display automatically returns to operating
message 1.
8.1 Program start
Display Meaning
Program
RM-310C
Version no. x
Date: xx.xx.20xx
The name of the program, the version number and the date of
the program release are displayed for approx. 4 seconds after
switching on the supply voltage.
The device powers up during
this time and conducts a self-test.
8.2 Operating message 1
Display Meaning
Stand-By
Row 1
The control is not released.
Only DP measurement
DP-contr. deactive
DP filter #### Pa
Row 1
Row 2
Row 2
Parameter D1 is set to 0.
Parameter D0 is set to the value 0.
#### currently measured differential pressure of filter
Clean.contr.inactive
DP-contr. deactive
DP filter #### Pa
Row 1
Row 2
Row 2
Parameter E0 is set to the value 0.
Parameter D0 is set to the value 0.
#### currently measured differential pressure of filter
Ext.cleaning off
Row 1
The input "Cleaning off" carries 1-signal at factory setting.
* The function of the inputs can be individually set via parameter group F0-
F8. See appendix 7 "Input and output signal parametrisation, special pa-
rameters" on this.
Downtime active
Row 1
The downtime is active.
Downtime is not externally released when the indicator flashes.