RECO RM-310 C - Operating Messages 2 to 4; Operating Message 5 - Only with Active Service Operating Hours Counter

Documentation RM-310 C / RM-310 CT / RM-310 C Plug and Play / RM-310 CT Plug and Play
RDN 10001104 35 14.07.2020
8.3 Operating messages 2 to 4
Operating messages 2 to 4 are the currently valid parameter values. The effective differential pressure is
displayed only when parameter D0 "Δp control" is set to value 1 (active).
Display Meaning
Operating message 2
DP-Min Al. #### Pa
DP-Max Al. #### Pa
DP Pre-Al. #### Pa
DP filter #### Pa
Row 2
Row 3
Row 3
Row 4
#### set value Δp-Min Alarm
#### set value Δp-Max Alarm
#### set value Δp-pre-alarm*
#### currently measured differential pressure of filter
* The operating message is displayed only when the parameter D9 Δp pre-
alarm is set to a value greater than 0 (alternating at 3-second cycle with
the value set for Δp Max. alarm).
Operating message 3
DP-Start 1200 Pa
DP-Stop 900 Pa
DP-Filter #### Pa
Row 2
Row 3
Row 4
Parameter "Starting cleaning"
Parameter "Stopping cleaning"
#### currently measured differential pressure of filter
Operating message 4
Interv.t. ##,# s
Pulse t. ### ms
Downtime ## cyc.
DP-Filter #### Pa
Row 2
Row 3
Row 4
Row 4
##,# effective value of interval
### effective value of pulse time
## effective value of downtime cycles*
#### currently measured differential pressure of filter
* The operating message is displayed only when downtime is active. If
downtime is not active, the currently measured differential pressure of the
filter is displayed instead.
8.4 Operating message 5 – only with active service operating hours counter
Display Meaning
Next service
Row 1 Next service
* #### h
Row 2
#### Time to next service
The asterisk symbol at the beginning of the row flashes when
the service operating hours counter is active.
Operating hours
Row 3 Elapsed general operating hours (mains on)
###### h
Row 4
######