Red Jacket Quick-Set UMP Series - Table of Contents

Table of Contents
iii
Introduction
Safety Precautions ............................................................................................................1
Warnings and Instructions ................................................................................................2
PRELIMINARY PRECAUTIONS ..............................................................................2
REQUIREMENTS FOR USE....................................................................................3
OPERATING PRECAUTIONS .................................................................................3
Fuel Compatibilities ..........................................................................................................4
Electrical Data and Service Information
Replacing the UMP for the Red Jacket STP .....................................................................8
Replacing the UMP for the Standard STP ......................................................................12
Test the Piping ................................................................................................................15
Figures
Figure 1. Identifying UMP Models By Their End View ...........................................8
Figure 2. Extractable Lock-Down Nuts ..................................................................9
Figure 3. UMP Bolts And Gasket ...........................................................................9
Figure 4. Verifying Pigtail’s Female Connector Is Seated Properly In
Discharge Head ....................................................................................10
Figure 5. Locating Packer And Manifold O-Rings ................................................11
Figure 6. Packer ...................................................................................................12
Figure 7. UMP Bolts And Gasket .........................................................................13
Figure 8. Verifying Pigtail’s Female Connector Is Seated Properly In
Discharge Head ....................................................................................14
Tables
Table 1. Maximum Specific Gravity And Maximum Viscosity ..................................4
Table 2. Electrical Service Information (For Umps Containing A
Franklin Motor With End View A) - For STPs With UL, cUL,
03ATEX0237289X, 04ATEX0330285X, 06ATEX6050X,
ANZEX 04.3005X Or POCC 05.B02160 Markings ....................................5
Table 3. Electrical Service Information (For UMPs Containing
A Faradyne Motor With End View B) - For STPs With UL, cUL,
03ATEX0237289X, 04ATEX0330285X Or 06ATEX6050X Markings .......6
Table 4. Electrical Service Information (For EN 15268 UMPs Containing
A Motor With End View B) - For STPs With UL, cUL, 03ATEX0237289X,
04ATEX0330285X, 06ATEX6050X Or 12ATEX1247797X Markings .......6
Table 5. UMP Model Dimensions ............................................................................7
Table 6. Approximate Pump Shut-Off Pressures ....................................................7