To Next PageTo Next Page
Need help?Do you have a question about the red lion RJS-PREM Series and is the answer not in the manual?
General| Brand | red lion |
|---|---|
| Model | RJS-PREM Series |
| Category | Water Pump |
| Language | English |
Understand safety symbols and signal words for potential hazards.
Ensure all electrical work complies with codes and is done by a licensed professional.
Measures to prevent electric shock, including grounding, disconnects, and keeping area dry.
Overview of pump application, quality, and emphasis on reading safety instructions carefully.
Step-by-step guide for qualified electricians to change the pump's voltage setting.
Lists all materials required for pipe connections, well setups, and tank integration.
Guidelines for properly joining PVC and metal pipe fittings using appropriate methods.
Details requirements for suction and pressure pipes, including valves.
Crucial safety steps before installation, including power shut-off and pressure relief.
A step-by-step guide for replacing an existing pump, covering plumbing and wiring.
Identification and specifications for various plugs on the pump.
Information on shallow well installations, suitable for depths up to 25 ft.
Detailed steps for installing the pump in drilled wells using a foot valve.
Guidance on installing the pump in a suitable location and adding a pressure gauge.
Detailed steps for installing the pump in driven wells using a well point and check valve.
Instructions for connecting the male galvanized adapter to the pump suction inlet.
Advises on installing a low pressure cut-off switch for well point installations.
Visual representations of various shallow well pump installation configurations.
Recommends using pre-charged diaphragm tanks for optimal system performance.
Explains the necessity of an air volume control for non-diaphragm tanks.
Guidance on checking and adjusting the tank pre-charge pressure for pump operation.
A table detailing friction loss in plastic pipes based on flow rate and pipe diameter.
Reiterates electrical precautions and safety guidelines to prevent electric shock.
Instructions for connecting electrical service to the pump, including voltage settings.
Recommended wire gauge based on motor HP, voltage, and wire length.
Critical warning against running the pump without priming to prevent damage.
Step-by-step procedure for priming the pump when using an inline check valve.
Step-by-step procedure for priming the pump when using a foot valve.
Safety during maintenance and routine monthly checks for pump integrity.
Procedure for draining the pump and tank to prevent freezing damage.
Instructions for disassembling and reassembling the pump to replace the mechanical seal.
Possible causes and solutions for the motor failing to start.
Identifies reasons why the pump might not deliver water or deliver it at a reduced rate.
Explains why the pump might lose its prime, such as air leaks.
Addresses issues causing the pump to cycle on and off too frequently.
Details the terms, conditions, and exclusions of the product warranty.
Clarifies that the Brand is not liable for field labor or other associated costs.
Outlines general terms and specific conditions that will void the warranty.
Disclaimer on oral statements, user liability assumption, and warranty limitations.
