Note: the Preview HD-SDI output provides 4 channels of embedded audio plus timecode.
Note: The embedded timecode value is equal to the Time Code value of the recorded
frame previewed by the PVW output. i.e. the timecode sequence will be discontinuous.
Note: RED ONE outputs progressive scan video, it does not support the 1080PsF format.
Note: If recording in ANA (anamorphic) mode, the Preview HD-SDI output will represent
the image in the final 2.40:1 aspect ratio. Only use this mode with 2:1 anamorphic lenses.
HDMI
An HDMI Type A connector provides an HDTV compatible 720p video and audio signal, or a
DVI / SXGA compatible 1280 x 848 progressive scan video signal, at 50.00 or 59.94 Hz.
Selection between these two modes is made in SYSTEM / MONITOR / PREVIEW. The default
setting is VIDEO (720p). In this mode, the HDMI output replicates the HD Preview video output.
Note: In this mode, if PLAYBACK is set to 1080p the HDMI output will provide a 1080p 10-
bit 4:2:2 progressive scan video signal with 4 channel embedded audio at 23.98, 24.00,
25.00, or 29.97 Hz when the RED-ONE camera is placed into playback.
The alternative mode is MENUS (DVI). In this mode, the HDMI output is compatible with most
DVI based SXGA or higher resolution computer monitors. Use is as an external Viewfinder.
Note: This mode is not compatible with PLAYBACK is set to 1080p.
i.e. no output is available when the RED-ONE camera is placed into playback.
Note: If recording in ANA (anamorphic) mode, the HDMI output will represent the image
in the final 2.40:1 aspect ratio. Only use this mode with 2:1 anamorphic lenses.
To Next Page
Loading...
Need help?
General
