15
Crankshaft problems
Big end nuts slacken
Solve vibration, see vibration.
Crankshaft bearing collapsed.
Incorrect assembled after repair.
Remove, clean, use loctite.
Rear roller shacking
Rear roller locked
Rear roller up with hollow coring
Tough circumstances
Unlock.
Change speed and PTO rev’s.
Put roller free on the ground.
Change machine settings.
13.0 MAINTENANCE
Pre-Delivery-Inspection
Grease crankshaft bearings
Check bolts/ nuts
Connect the unit to a tractor
Run unit for 5 min
8 shots each EP 2
See instructions in this manual
Look and listen
After first 20 hours
(new or repaired)
Grease crankshaft bearings
Grease PTO and rollers
Check bolts/nuts
Look closely at machine
4 shots each EP 2
4 shots each EP 2
After every 100 hours
Grease crankshaft bearings
Grease PTO and rollers
Check bolts/ nuts
Look closely at machine
Grease spindles front roller
6 shots each EP 2
4 shots each EP 2
14.0 EU-Declaration
.
We, Redexim Utrechtseweg 127 3702 AC Zeist Holland, hereby declare fully on our authority that
the product:
VERTI-DRAIN 7516, WITH MACHINE NUMBER AS INDICATED ON THE MACHINE AND
IN THIS MANUAL,
to which this declaration applies, has been manufactured in line with NEN-EN 12100-1,
NEN 12100-2 and NEN-EN 294, according to the stipulations of: The Machine Directive 98/37/EG.
A.C. Bos
Manager Opertions and Logistics
Redexim Holland
To Next Page
Loading...
