Redexim Verti-Drain 7516 - Rear Roller Extension Kit

24
@ When we apply too much spring force on the tines ( especially in combination with the 12 mm (
½”)), we may destroy the hole edge, since the spring is pulling hard at the moment the tines are
leaving the ground. Extra spring force is not advised for such applications.
16.1.5 Rear roller extension kit
The kit 211.752.002 can be mounted at the standard rear roller supports and moves the roller
further away from the moving parts inside the machine.
Since the rear roller is further away from the machine, special attention for shaking of the
rear roller is necessary under tough circumstances. If the shaking goes on for a longer while,
the rear roller scraper ends may break together with the rear roller bearings.
Assemble the kit the way it is drawn above. Tighten all bolts and nuts.