Redlion RL-MP25A - User Manual

Questions and Answers

S
Sheila DixonJul 29, 2025
What to do if my Redlion RL-MP25A Water Pump does not turn on?
- N
  nhamiltonJul 29, 2025
  If your Redlion water pump isn't turning on, there are several things you can check: * Ensure the pump is properly plugged in. * Check the circuit breaker to see if it's off, and turn it on. If there is a fuse, check to see if it needs replacing. * Allow the pump to operate for at least 5 minutes. The pump must sit for 3-5 minutes before turning on to check for water. * If none of these steps work, the motor may be defective, and the pump may need to be replaced.
L
Lori DavidsonAug 3, 2025
Why does my Redlion RL-MP25A run but not discharge liquid?
- E
  elizabeth34Aug 3, 2025
  If your Redlion water pump runs but doesn't discharge liquid, here's what you can check: * The lift may be too high for the pump. Check the rated pump performance to ensure it's within the pump's capabilities. * The inlet to the impeller might be plugged. Pull the pump and clean it. * The pump could be air locked. Remove the pump and clean the air bleed hole.
C
Christy PowersAug 9, 2025
How to fix a Redlion RL-MP25A Water Pump that will not shut off?
- J
  Janice WatkinsAug 9, 2025
  If your Redlion water pump won't shut off, here are a few things to investigate: * The pump may be air locked. Release air from the discharge. * The liquid inflow might match the pump's capacity. If so, a larger pump is required. * The impeller or discharge pipe could be clogged. Pull the pump and clean it. Also, check the pipe for scale or corrosion.
N
Natalie LeeAug 16, 2025
What to do if my Redlion RL-MP25A Water Pump turns off after starting?
- P
  Patricia RowlandAug 16, 2025
  If your Redlion water pump starts but then turns off, consider these potential causes: * Incorrect voltage could be the issue. Check the power supply to ensure it's correct. * Excessive flow restriction may be present. Remove any kinks or other restrictions in the hose. * The pump could be air locked. Try releasing air from the discharge.
L
lisahartAug 22, 2025
Why Redlion RL-MP25A Water Pump does not deliver rated capacity?
- J
  Jamie GutierrezAug 22, 2025
  If your Redlion water pump isn't delivering its rated capacity, consider the following possible causes: * The lift might be too high for the pump. Check the rated pump performance. * Low voltage could be causing the speed to be too slow. Ensure the supply voltage matches the nameplate rating. * The impeller or discharge pipe could be clogged. Pull the pump and clean it, and check the pipe for scale or corrosion. * Impeller wear due to abrasives can reduce capacity. If this is the case, replace the pump.