Need help?Do you have a question about the Redring 1070800E and is the answer not in the manual?
General| Brand | Redring |
|---|---|
| Model | 1070800E |
| Category | Water Heater |
| Language | English |
Details the step-by-step process of filling and heating the water heater from initial setup to maintaining temperature.
Troubleshooting steps for when the unit fills to a low level but fails to heat the water.
Diagnostic guide for issues where the water heater fails to fill with water, checking probes and valves.
Solutions for an overheating unit, involving checking sensors and potentially replacing the PCB.
Guidance on checking water supply, element, and replacing the manual reset thermostat for boil-dry protection.
Steps to resolve tap leaks by replacing the tap cup seal or the entire tap assembly.
Addresses slow operation by checking for blockages in the cold water supply tube.
Procedure for safely removing the front cover to access internal components.
Instructions for disconnecting and replacing the water solenoid valve.
Steps for removing and replacing the heating element and ensuring a watertight seal.
Procedure for replacing the tap assembly, emphasizing new thread seal tape.
Guidance on removing and replacing the manual reset thermostat.
Instructions for disconnecting and replacing the Printed Circuit Board (PCB).
Steps for replacing the thermistor steam sensor, including probe placement and PCB connection.
To Next Page
