Full details of terms and conditions are available on request from: -
APPLIED ENERGY PRODUCTS LIMITED,
MORLEY WAY, PETERBOROUGH PE2 9JJ
TEL +44 (0) 844 372 7750 / FAX: +44 (0) 844 372 7760
Website: www.applied-energy.com
(A4 Leaflet No. 578-2018-12a)
THIS APPLIANCE IS NOT INTENDED FOR USE BY PERSONS
(INCLUDING CHILDREN) WITH REDUCED PHYSICAL, SENSORY OR MENTAL
CAPABILITIES, OR LACK OF EXPERIENCE AND KNOWLEDGE, UNLESS THEY
HAVE BEEN GIVEN SUPERVISION OR INSTRUCTION CONCERNING USE
OF THE APPLIANCE BY A PERSON RESPONSIBLE FOR THEIR SAFETY.
CHILDREN SHOULD BE SUPERVISED TO ENSURE THAT THEY
DO NOT PLAY WITH THE APPLIANCE.
We recommend that the installation should only be carried out by a suitably qualified
person.
The Redring WS7-EcoT heater is an open outlet, thermal storage water heater for use
with Redring recommended fittings for one outlet only.
It operates on the displacement principle i.e. when cold water is admitted into the
bottom of the tank, hot water flows out through the outlet.
Installation
We recommend that this unit should be installed in the following order:
1. Fit wall bracket.
2. Fit mains electrical cable to the unit.
3. Fit heater to the wall.
4. Connect plumbing to the unit.
5. Replace the front cover.
6. Fill the unit with water and check for leaks.
7. Connect mains electrical cable to the fixed wiring.
8. Set the weekly mechanical timer.
9. Turn unit on and check operation.
10. Demonstrate operation to user.
Please Note:-
When removing the front cover, we recommend that you first remove the two top fixing
screws, but only LOOSEN the two bottom screws.
This will aid when replacing the front cover during installation.
To Next Page
Need help?
General
