2 Instructions for use and maintenance
Thank you for purchasing a quality Redring appliance.
To enjoy your new unit at its best, please take time to read
this manual thoroughly to familiarise yourself with all
instructions, BEFORE beginning installation.
If you experience any difficulty with the installation or
operation of your new water heater, then please refer to
the “What to do if things go wrong” section in this manual
before contacting us.
THIS APPLIANCE CAN BE USED BY CHILDREN AGED FROM
8 YEARS AND ABOVE AND PERSONS WITH REDUCED
PHYSICAL, SENSORY OR MENTAL CAPABILITIES, OR LACK
OF EXPERIENCE AND KNOWLEDGE IF THEY HAVE BEEN
GIVEN SUPERVISION OR INSTRUCTION CONCERNING USE
OF THE APPLIANCE IN A SAFE WAY AND UNDERSTAND THE
HAZARDS INVOLVED.
CHILDREN SHALL NOT PLAY WITH THE APPLIANCE.
CLEANING AND USER MAINTENANCE SHALL NOT BE MADE
BY CHILDREN
THE WATER MAY DRIP FROM THE DISCHARGE PIPE OF THE
PRESSURE-RELIEF DEVICE AND THE PIPE MUST BE LEFT
OPEN TO THE ATMOSPHERE;
THE PRESSURE-RELIEF DEVICE IS TO BE OPERATED
REGULARLY TO REMOVE LIME DEPOSITS AND TO VERIFY
THAT IT IS NOT BLOCKED;
IF THE POWER CORD (OF MODELS THAT HAVE ONE) IS
DAMAGED, IT MUST BE REPLACED IMMEDIATELY BY AN
APPROPRIATELY QUALIFIED PERSON, IN ORDER TO AVOID
ANY RISKS.
REDRING AFTER SALES SERVICE
We offer a technical advisory service on the telephone to
installers and other customers with problems in the field.
RING 0844 372 7766* (UK ONLY)
Or alternatively email us on:
Service.request@redringxpelair.com
Remember to quote the exact type of unit, as written on
the front of the unit and on this leaflet. The model and
serial number are located on the unit.
Make a note of those numbers here, and be sure to quote
them if you call for advice.
Model Number:
Serial Number:
NOTE: You may be charged for a service call if you do
not have the serial number
IMPORTANT SAFETY INFORMATION
Your TS Line Heater has been designed for convenience,
economy and safety of use, provided that it is installed,
used and maintained in good working order and in
accordance with our instructions and recommendations.
•
All wiring and installation must be supervised by a
suitably qualified person.
•
THIS APPLIANCE MUST BE EARTHED.
•
The installation must be in accordance with
the current edition of BS.7671 (the “IEE Wiring
Regulations”) and “Part P” of the “Building Regulations”
in force at the time of installation. Installations outside
England and Wales must also conform to any local
regulations in effect.
•
This appliance is intended to be permanently
connected to the fixed electrical wiring of the mains
supply with its own dedicated supply OR using the
plug provided.
•
Ensure that the mains water supply meets the
requirements listed.
•
This appliance must NOT be fitted where it may be
subjected to freezing conditions. DO NOT switch the
appliance on if you suspect it of being frozen. Wait
until you are sure it has thawed out.
•
The unit MUST NOT be mounted upside down.
•
The unit MUST NOT be fitted to any type of
THERMOSTATIC mixer valve or tap.
•
If a non-return valve is fitted in the Inlet feed to the
unit, then the installation should also include a 3.5
BAR Pressure Reducing Valve and a 6 BAR Pressure
Relief (Expansion) Valve.
•
Isolate the mains electrical and water supply before
removing the front cover of the appliance.
THIS APPLIANCE CAN BE USED BY CHILDREN
AGED FROM 8 YEARS AND ABOVE AND PERSONS
WITH REDUCED PHYSICAL, SENSORY OR MENTAL
CAPABILITIES, OR LACK OF EXPERIENCE AND
KNOWLEDGE ONLY IF THEY HAVE BEEN GIVEN
SUPERVISION OR INSTRUCTION CONCERNING USE OF
THE APPLIANCE IN A SAFE WAY AND UNDERSTAND THE
HAZARDS INVOLVED.
CHILDREN SHALL NOT PLAY WITH THE APPLIANCE.
CLEANING AND USER MAINTENANCE SHALL NOT BE
MADE BY CHILDREN.
*Calls to this number cost 7p per minute plus your telephone company’s network access charge
To Next Page
Loading...
Need help?
General
