Redsun PF2100 - USING THE SNOOZE FUNCTION; ADJUSTING THE SLEEP TIME

13
and turn off the radio, the sign or sign will no longer flash.
 If the radio is set to local time, the timer settings will work according to
the local time; If the radio is set to world time, the timer settings will
work according to the word time.
3. Using the Snooze Function
 When the timer is activated, press the SNOOZE button (2) once will
temporarily turned off the buzzer or the radio, the snooze function is
now enabled.
 Five minutes later, the timer will be in active mode again.
 If there is no further manual intervention, the buzzer will sound for 3
minutes or the radio will be turned on for 60 minutes, then the radio
will be turned off automatically.
 This Snooze function can be repeated 4 times.
 When the SNOOZE button (2) is pressed for the 5
th
time, the timer
function will be disabled.
4. Adjusting the Sleep Time
 Press the POWER / SLEEP button (8) once, the LCD panel will
display the “60” and the signs, representing that the radio will
be turned off in 60 minutes time.
 If you wish to change the sleep time, press the POWER / SLEEP
button (8) again before it disappears, the figures on the LCD panel
will change as follows:
90 -> 60 -> 45 -> 30 -> 15 -> 5 -> 1 -> on -> (back to 90)
 If you stop at 30, the radio will be turned off automatically within 30
minutes.
 If you stop at “on”, the radio will be turned on until further manual
intervention, the will not appear on the LCD panel.