9
D. SPECIAL FUNCTIONS
1. MW AND SW GAIN CONTROL
When listening to MW or SW stations, normally the RF GAIN Knob
(27) should be set to full for best sensitivity.
In case the station is of very strong signal, the signal may be
overloaded resulting in distortion of sound quality, the RF GAIN Knob
(27) should be turned counter-clockwise to eliminate the distortion.
If the area where you use this radio is polluted with noise and
interference, adjust this Knob (27) to lower the sensitivity may
sometimes help to alleviate the interference.
2. DX / LOCAL SWITCH
The DX / LOCAL Switch (12) on this radio may be used to overcome
interference of strong signals in the SW and MW bands.
Normally, the DX / LOCAL Switch (12) should be set to DX. When
there is strong RF, VHF or BP signal intruding into the MW or SW
bands, set this switch (12) to LOCAL may help to suppress such RF
interferences.
3. AUDIO LINE OUT
You can connect radio to an external amplifier via the LINE OUT
Socket for more powerful and better sound quality.
Set the AM / FM MODE Switch to the FM Stereo position when
listening to FM stereo programs. The sign “STEREO” will display on
the LCD panel.
The VOLUME (24) control knob would not change the sound level of
the LINE OUT function.
To Next Page
Loading...