1 4
www.REEDINSTRUM EN TS.com
Bat t er y Replacement
1. The battery should be replaced when is displayed.
2. Remove the screw with a áat screwdriver and open the battery cover.
3. Replace the 9V battery.
4. Place the battery cover back and tighten the screw.
Applicat ions
• Verify mechanical (bearings, motors) or electrical
(circuit breaker boxes) equipment
• Calibration and control of heater and oven temperatures
• Monitoring materials in processes involving heating and/or cooling
• Quality control monitoring
• Research and development applications
• Automotive diagnostics
• Conduct HVAC energy audits
REED Inst r ument s
1 -8 7 7 -8 4 9 -2 1 2 7 | info@r eedinst r ument s.com | www.r eedinst r ument s.com
To Next Page
Loading...
