3
www.REEDINSTRUM EN TS.com
Int r oduct ion
Thank you for purchasing your REED R2310 Infrared Thermometer. Please
read the following instructions carefully before using your instrument. By
following the steps outlined in this manual your meter will provide years of
reliable service.
Pr oduct Qualit y
This product has been manufactured in an ISO9001 facility and has been
calibrated during the manufacturing process to meet stated product
speci cations. If a certi cate of calibration is required please contact the
nearest authorized REED distributor or authorized Service Center. Please
note an additional fee for this service will apply.
Safet y
• Never attempt to repair or modify your
instrument. Dismantling your product,
other than for the purpose of replacing
batteries, may cause damage that will
not be covered under the manufacturer’s
warranty. Servicing should only be
provided by an authorized service center.
• Use extreme caution when the laser beam
is turned on.
• Do not let the beam enter your eye, another person's eye or the eye of
an animal.
• Be careful not to point the beam off a reáective surface and strike your eye.
• Do not allow the laser light beam to impinge on any gas which can explode.
REED Inst r ument s
1 -8 7 7 -8 4 9 -2 1 2 7 | info@r eedinst r ument s.com | www.r eedinst r ument s.com
To Next Page
Loading...
Need help?
General
