Reef Factory Thermo control - Assembly of the Device; Mount the Device; Install Temperature Sensor; Connect Heating and Cooling Devices

I. Assembly of the device
1. Mount the device
Using the holes on the back of the device, mount it in
a safe place away from water and vapors.
Connect the device to the power supply.
Using the power cord
included in the set, connect the device to the
mains socket. Insert the power cord into a tightly
fitting socket, make sure that the cord is not loose.
2. Install the temperature sensor in the water.
ATTENTION! The sensor must be in a safe place with a constant temperature.
Place it away from water surfaces and heat sources such as heaters.
3. Connect the heating and cooling device as marked.
Manual Thermo control © Reef Factory 2023
3