Reef Factory Thermo control User Manual

V. Resetting the device
If your device is not working properly, you
want to configure it again or you cannot
connect to it after several attempts, you can
restore it to factory settings by applying the
magnet (included in the set) to the device's
housing in the place marked RESET.
After resetting the device to factor y settings,
reconfiguration and calibration is required.
VI. Changing the device access password
For security reasons, it is recommended to change the standard device
access password. The password should be suciently complex to
prevent third parties from connecting to the device. Changing the
password requires a direct connection to the device's WiFi network as
in step 4 of Initial Device Setup.
Once you are connected to the device, expand the list by clicking on the
3 bars in the upper right corner of the screen, then go to the WiFi
network settings.
Enter your current password (default is reeffactory)
then press "OK".
In the next step, enter a new password and press "OK",
then confirm the new password and press "OK".
Congratulations! The password has successfully changed
Manual Thermo control © Reef Factory 2023
12

Reef Factory Thermo control Specifications

General

Brand	Reef Factory
Model	Thermo control
Category	Thermostat
Language	English