Page | 3 Ascento 37 Export St Lytton QLD PH: 1800 807 604 | VSRM Inverter Contant Pressure Pumps | V2016.12
WARNING: If the VSD is damaged do not attempt to use the device, it may damage the pump and
you may be at risk of harm.
2.4 Additional safety warnings;
1. Please be sure to use the correct power supply - refer to the nameplate.
2. Disconnect power supply when installing and maintaining this product. This product must
be earthed according to Australian electrial safety standards.
3. DANGER: NOT TO BE USED IN HAZARDOUS AREAS. Not to be used with hazardous,
corrosive, flammable or explosive substances, or in any area that is deemed to be a high-
risk area.
4. Don't install the VSRM underwater or in any place where water may be splashed or
sprayed onto the controller, it must be in a well ventilated and well drained area,
protected from the weather, dust, dirt, leaves, insects, rodents, reptiles etc, by way of a
pump cover or a weatherproof enclosure. Installation under eaves of houses is not an
acceptable level of protection from the weather.
5. This pump is not to be used as your sole water supply. For critical applications where loss
of water supply could cause serious consequences, use a DUAL PUMP System so you have
a backup water supply or use a TOWN-WATER BACK-UP System.
6. This pump MUST NOT be installed in any manner that if it were to leak, or fail to work, that
it would cause damage or loss to property or persons.
7. If the device will not be used for 18 months or more, the capacitors must be replaced by a
licenced Electrician, before it is used again.
8. Don't open the cover or touch the controller terminals when power is on, no exceptions.
9. Always wait for 5 minutes after the power is isolated, ensure all the indicator lights are out
completely, before opening the cover, otherwise there is risk of electric shock.
10. Ensure hands are dry while operating the control panel, do not use wet hands.
11. If the wiring is damaged or perished, it must be replaced by a licenced Electrician.
12. Installation and the operation must comply with all applicable safety, electrical & plumbing
regulations. It is the installer’s responsibility to ensure compliance; all warranty is void if
this is not followed.
13. Installation and maintenance is only to be carried out by qualified persons, all electrical
work must be performed by a licenced Electrician.
14. The Installer takes responsibility for the correct installation, and must ensure the Owner or
delegated person is competent in maintenance, and the Owner takes responsibility that
maintenance is only performed by competent persons.
15. If the motor overheats, please close the inlet valve immediately and turn off the power
supply, contact your installer or dealer or service centre do not contact us as we have no
knowledge of your installation. The pump is not to be used again until the fault is
investigated and rectified.
16. If you cannot eliminate the pump fault simply, please close the inlet valve immediately and
cut off the power, contact your installer or dealer or service centre. Do not contact us as
we have no knowledge of your installation. The pump is not to be used again until the fault
is investigated and rectified.
17. Isolation measures must be taken so as to protect the VSRM from interference by children,
incompetent persons, vandals and wildlife.
18. If the ambient temperature and/or humidity is high, the VSRM controller must be
sufficiently ventilated to avoid electrical failure from condensation.
To Next Page
Loading...