EasyManua.ls Logo

Reely Deathwatcher EVO 4WD ARR - Assembly Safety; Commissioning Safety

Reely Deathwatcher EVO 4WD ARR
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
34
b) Assembly
• Whensettingupthevehicle,thereisadangerofinjuryfromsharpedges,pointypartsandimproperhandlingof
tools.
• Incorrectassemblymayleadtodamagetovehiclepartsandlatertobaddrivingperformance.Therefore,proceed
with care during assembly.
• Onlysetupthevehicleonaclean,sufcientlylarge,level,stablearea,protectthesurfacefromscratches,e.g.ofa
work table with a suitable thick padding.
• Donotapplyanyforcewhenputtingtogetherparts;donotoverturnscrews!However,observethatthescrews,nuts,
etc. are fastened correctly.
Use screws/nuts with special threadlocker varnish for certain locations subject to special strain.
• Usesuitable,impeccablehigh-qualitytoolsforinstallation.
• Takeyourtime!
• Fastenthespeedcontrollerused byyou,e.g.,withdouble-sidedadhesive tape(orhook-and-looptape)in the
vehicle.
• Installthespeedcontrollerinthevehicleasfaraspossibleawayfromthereceiverandmotor.
• Donotbundlethecablesbetweenthemotorandspeedcontrollerwiththecontrolcablesofthesteeringservoand
the speed controller or the aerial cable.
• Observethatthecablesfromthereceiver,steeringservo,motoranddrivingbatterycannotbetintoturningormov-
able parts of the vehicle. Use cable ties for fastening the cables.
• Thevehicle'schassis(trackandcamber)ispre-setexworks.Usually,nooronlysmallcorrectionsareneeded.
Nevertheless, always observe the corresponding sections of these operating instructions.
c) Commissioning
• Thedrivemechanicsaredesignedforanelectricmotorandamatchingelectronicspeedcontroller.Neverinstalla
combustion motor.
• Thevehicleandthebuildofthebatteryholderarespecicallyintendedfora2-cellLiPodrivebattery(ratedvoltage
7.4V)inhard-casebuild.Alternatively,a6-cellNiMHdrivebattery(ratedvoltage7.2V)canbeused.
Whenusingadrivebatterywithmultiplecells,thevehicledrivewilloverloadandthusbedamaged(e.g.gear,dif-
ferential). Loss of guarantee/warranty!
• Placethevehicleonanappropriatesupportbeforeconnectingthedrivebatterysothatthewheelscanturnfreely.
Whenputtingthedeviceintooperation,alwaysturnonthetransmitterrst.Onlythenmustthevehicle'sdrivebat-
tery be connected with the speed controller and the speed controller switched on. Otherwise, the vehicle may show
unpredictable responses!
• Checkthatthevehiclereactstoremotecontrolcommandsasexpected(steeringanddrive)beforetakingitfromthe
support and placing it on the ground with its wheels.

Table of Contents