Reely Deathwatcher EVO 4WD ARR - Page 46

46
Example:
Set ball-head screw Tighten/loosen plastic grub screw
Set camber more negatively:
Turntheupperball-headedscrew(A)totherightclockwise,andthelowerball-headedscrew(B)totheleftcounter-
clockwise(eachwithasmall2.5mmhexagonwrench(D)).
Set camber more positively:
Turntheupperball-headedscrew(A)totheleftcounter-clockwise,andthelowerball-headedscrew(B)totheright
clockwise(eachwithasmall2.5mmhexagonwrench(D)).
 Twistthetwoball-headscrews(A)and(B)withthesmall2.5mmhexagonwrench(D)inoppositedirections
(!)atalltimesandalwaysbythesameangle(e.g.aquarterturntotheleftorright).
We recommend always changing the setting only by a quarter turn at a time and then reviewing the driving
behaviour. Write down the changes so that you can reverse them again if necessary.
 Thesmallhexagonholeoftheball-headscrews(A)and(B)isonlyvisiblewhenlookingrightthroughthe
largehexagonholeoftheplasticgrubscrews(C).
Do not turn out the ball-head screws too far since the axle stub will no longer stick to the transverse link
otherwise.
Thencheckthatthewheelsuspensioncanbemovedfreely(thewheelcanextendanddeect).Ifthisisnotthe
case,loosentheplasticgrubscrews(C)withthelarge5mm-hexagonwrench(E);forthis,turnitasmallbittothe
left counter-clockwise.
Iftheaxlestubiswobblyatthetransverselinks,turntheplasticgrubscrews(C)intotherightclockwisewiththelarge
5mm-hexagonwrench(E).Donotapplyanyforce,asdescribed,sincethewheelsuspensioncannotmoveotherwise
andthewheelthuscannotextendordeect.
Theballheadscrews(AandB)mustnotbefastenedrmlywiththeplasticgrubscrews(C),butmustbeplay-free.
D
E