Reer ARGOLUX AS Series User Manual

When the optimum adjustment is achieved, rigidly fix both emitter and
receiver.
If the emitter and the receiver are installed on machines exposed to high
vibrations, it is recommended to use antivibration dampers to keep optics
aligned (see figure 16).
INSPECTION AND MAINTENANCE
INSPECTION AND MAINTENANCEINSPECTION AND MAINTENANCE
INSPECTION AND MAINTENANCE
Inspection.
Inspection.Inspection.
Inspection.
Each time the machine is powered up, it is necessary to test
Each time the machine is powered up, it is necessary to testEach time the machine is powered up, it is necessary to test
Each time the machine is powered up, it is necessary to test
the correct response of the safety curtain over the whole
the correct response of the safety curtain over the wholethe correct response of the safety curtain over the whole
the correct response of the safety curtain over the whole
protection field.
protection field.protection field.
protection field.
The following procedure using the test rod provided with the Argolux AS
system must be carried out.
Fig. 16
Fig. 16Fig. 16
Fig. 16
Mounting of brackets and antivibration dampers.
Mounting of brackets and antivibration dampers.Mounting of brackets and antivibration dampers.
Mounting of brackets and antivibration dampers.
!
29
2929
29

Reer ARGOLUX AS Series Specifications

General

Brand	Reer
Model	ARGOLUX AS Series
Category	Safety Equipment
Language	English