Need help?Do you have a question about the Reflex variomat 2-2/95 and is the answer not in the manual?
General| Brand | Reflex |
|---|---|
| Model | variomat 2-2/95 |
| Category | Control Systems |
| Language | English |
Provides a diagram and list of hydraulic components for the 'variomat' control unit and VG basic vessel.
Explains the LCD display, operating mode buttons, and control buttons for Variomat 2 and 1 models.
Illustrates various installation variants for the control unit with single-pump and dual-pump systems.
Guides on aligning and connecting the VG basic vessel to the control unit and associated components.
Provides instructions for mounting the level gauge onto the VG basic vessel.
Covers sizing, integration, and connection of expansion lines for the system.
Details electrical wiring requirements and safety precautions for qualified electricians.
Lists essential checks and requirements before starting the 'variomat' system.
Guides through the initial controller setup, including language and minimum pressure settings.
Continues the start routine, covering time, date setting, and auto-zeroing of the level gauge.
Describes methods for filling the vessels and the procedure for bleeding air from the pumps.
Lists specific error codes, their causes, and troubleshooting or remedy actions.
Outlines annual maintenance tasks, including leak testing and general checks.
To Next Page