Need help?Do you have a question about the Reflex Variomat Touch VS 2-1/35 and is the answer not in the manual?
General| Brand | Reflex |
|---|---|
| Model | Variomat Touch VS 2-1/35 |
| Category | Control Systems |
| Language | English |
Explains symbols and signal words used in the manual.
Specifies qualifications for personnel performing installation and maintenance.
Details the use of prescribed personal protective equipment.
Defines the device's purpose as a pressure maintaining station for HVAC systems.
Lists applications and conditions where the device must not be used.
Highlights potential residual risks, such as burns from hot surfaces.
Introduces the Variomat with touch control as a pressure maintaining station.
Illustrates the device components with a diagram and numbered parts.
Explains how to identify the device through its nameplate and type code.
Details information found on the device's nameplate.
Explains the structure and meaning of the device's type code.
Illustrates the functional principle of the device with a diagram.
Provides technical specifications for the I/O module.
Explains how to configure the I/O module settings.
Lists technical data for the control unit.
Specifies technical data for the primary and secondary tanks.
Specifies the required environmental and site conditions for installation.
Details the procedure for inspecting the device upon receipt.
Guides on how to position the control unit and tanks.
Explains how to install accessory components onto the tanks.
Explains connecting the control unit to the facility system.
Describes the basic function of level monitoring and automatic make-up.
Illustrates the make-up function in a single-tank system.
Shows the make-up function in a district heating substation.
Provides a diagram showing terminal connections for the device.
Details the terminal plan for the connection component.
Guides on connecting the RS-485 interface to the main circuit board.
Lists the prerequisites that must be met before commissioning.
Explains how minimum pressure determines switching points.
Explains how to fill the tank using a water hose.
Details filling the tank using the automatic make-up valve.
Explains the automatic operation mode and its functions.
Details the manual mode for testing and maintenance tasks.
Describes the stop mode for device commissioning and after repairs.
Describes the layout and functions of the controller's operator panel.
Provides instructions for calibrating the touch screen display.
Explains how to configure controller settings for active operating modes.
Details how to use the Customer menu to adjust system-specific values.
Summarizes regular maintenance tasks and their frequencies.
Outlines compliance with regulations for pressure equipment.
Refers to regulations for pre-commissioning inspections.
Specifies recommended maximum inspection intervals.
Provides contact information for Reflex Customer Service.
States where to find device conformity declarations and standards.
Mentions that statutory guarantee regulations apply.
To Next Page
