Regal-Beloit GE ECM X13 - Page 72

© 2006 GE ECM by Regal-Beloit - 70 - Indoor Blower Motors v0.2
Final installation checks
 Check all wiring and connections, especially those removed while servicing.
Ensure the system is setup as follows:
 Verify the condensate drain is not plugged or clogged.
 Reconnect the AC power to the HVAC system and verify that the new motor
control module is working properly.
 Check and plug leaks in return ducts and equipment cabinet.
 Verify that the system is running quietly and smoothly, in all modes (heating,
cooling, and continuous fan) and all stages (if applicable).
 Return all thermostat settings to the customer’s preference.
Note: If this is a repeat failure, then it is important that you check the
following:
 Any evidence of moisture requires correcting the issue.
 If this area is subject to high amounts of lightning strikes, the use of
additional transient protection may be helpful.
Good Practices
 Finish all service calls by checking all safeties, and perform a visual
inspection of the overall job to prevent call-backs.
 Check the level of Carbon Monoxide (CO) in the vent(s) and living spaces of
all homes with fossil-fuel appliances.
 Recommend annual maintenance